'Stop tcp packets from concatenating
I have two apps sending tcp packages, both written in python 2. When client sends tcp packets to server too fast, the packets get concatenated. Is there a way to make python recover only last sent package from socket? I will be sending files with it, so I cannot just use some character as packet terminator, because I don't know the content of the file.
Solution 1:[1]
TCP uses packets for transmission, but it is not exposed to the application. Instead, the TCP layer may decide how to break the data into packets, even fragments, and how to deliver them. Often, this happens because of the unterlying network topology.
From an application point of view, you should consider a TCP connection as a stream of octets, i.e. your data unit is the byte, not a packet.
If you want to transmit "packets", use a datagram-oriented protocol such as UDP (but beware, there are size limits for such packets, and with UDP you need to take care of retransmissions yourself), or wrap them manually. For example, you could always send the packet length first, then the payload, over TCP. On the other side, read the size first, then you know how many bytes need to follow (beware, you may need to read more than once to get everything, because of fragmentation). Here, TCP will take care of in-order delivery and retransmission, so this is easier.
Solution 2:[2]
TCP is a streaming protocol, which doesn't expose individual packets. While reading from stream and getting packets might work in some configurations, it will break with even minor changes to operating system or networking hardware involved.
To resolve the issue, use a higher-level protocol to mark file boundaries. For example, you can prefix the file with its length in octets (bytes). Or, you can switch to a protocol that already handles this kind of stuff, like http.
Solution 3:[3]
First you need to know if the packet is combined before it is sent or after. Use wireshark to check it the sender is sending one packet or two. If it is sending one, then your fix is to call flush() after each write. I do not know the answer if the receiver is combining packets after receiving them.
You could change what you are sending. You could send bytes sent, followed by the bytes. Then the other side would know how many bytes to read.
Solution 4:[4]
Normally, TCP_NODELAY prevents that. But there are very few situations where you need to switch that on. One of the few valid ones are telnet style applications.
What you need is a protocol on top of the tcp connection. Think of the TCP connection as a pipe. You put things in one end of the pipe and get them out of the other. You cannot just send a file through this without both ends being coordinated. You have recognised you don't know how big it is and where it ends. This is your problem. Protocols take care of this. You don't have a protocol and so what you're writing is never going to be robust.
You say you don't know the length. Get the length of the file and transmit that in a header, followed by the number of bytes.
For example, if the header is a 64bits which is the length, then when you receive your header at the server end, you read the 64bit number as the length and then keep reading until the end of the file which should be the length.
Of course, this is extremely simplistic but that's the basics of it.
In fact, you don't have to design your own protocol. You could go to the internet and use an existing protocol. Such as HTTP.
Sources
This article follows the attribution requirements of Stack Overflow and is licensed under CC BY-SA 3.0.
Source: Stack Overflow
| Solution | Source |
|---|---|
| Solution 1 | Has QUIT--Anony-Mousse |
| Solution 2 | user4815162342 |
| Solution 3 | Robert Jacobs |
| Solution 4 |