'Rectifier circuit for twin filament halogen bulb H4 and LEDs
I am trying to make a rectifier/rectifying circuit for an H4 bulb, automobile twin filament bulb, although a simple full bridge rectifier is working for one filament, but when I try to make two for one HIGH BEAM and another LOW Beam, obviously the entire circuit becomes one and voltage is supplied to both the filaments.
How can I fix it?
The problem is the input is AC from the vehicle and the output has to be DC for either HIGH BEAM or LOW BEAM. From the vehicle there are three wires coming, one ground one high one low (all AC). And each has to go DC for the LEDs to lighten up.
Sources
This article follows the attribution requirements of Stack Overflow and is licensed under CC BY-SA 3.0.
Source: Stack Overflow
| Solution | Source |
|---|