'CmdLet works in PowerShell but not in PowerShell ISE
Lately I have been developing PowerShell scripts on a Window 8 machine instead of on a Windows Server 2012R2 which I normally do.
I have encountered two very strange things that never happened on the server. I know, two questions in one post, but I believe they might be connected.
After a while cmdlets just stop producing any output whatsoever, no error messages, no verbose output. It doesn't matter if I run it in the "lower" command part or in the "upper" script editor, and no difference if I run a selected part of the script or the whole thing. If I switch to a "normal" PowerShell the cmdlet works fine. If I restart PowerShell ISE, the cmdlet start working again, but only for a like 2-5 execution (not at all exact number) after which it stops working again. Not all cmdlets behave this way, mostly had problems with Storage related cmdlets (Format-Partition, Get-Disk, Get-Volume and so on).
After a while cmdlets that used to work fine in the "upper" script part of PowerShell ISE just stops working. The cmdlets still work fine in the "lower" command part of the ISE GUI, but does not work when used in the "upper" script editor, even though they did just a second ago. And it doesn't matter if I run the whole script or just a selected part. And by not working I mean it can't even find the cmdlet (The term '' is not recognized as the name of a cmdlet). The cmdlet is available in the Commands Side-Bar where it show up without any problem and I can access help for it.
So any ideas what is going on here?
Sources
This article follows the attribution requirements of Stack Overflow and is licensed under CC BY-SA 3.0.
Source: Stack Overflow
| Solution | Source |
|---|