I am trying connect my stm32f103c8 board to PC with several examples from internet, but all of them face the same issue, they can not be installed successfully.
I have predefined addresses (address1,address2 and address3) and i want to : If each address variables is equal to the first 6 variables of my data then i want
somehow when i am running my code, it seems like one GPIO Port isn't being initialized, meanwhile if i am debugging, it is. I am initializing two sensors: struc
I am having a problem about RTC Alarm configuration. First of all, I tried example code which is provided by Cube, and It works. But in my code, it doesn't work
I am having a problem about RTC Alarm configuration. First of all, I tried example code which is provided by Cube, and It works. But in my code, it doesn't work
I want to configure PLL in STM32F429 to its max frequency (180Mhz) without using STMCube-generated configurations. I am using my own register definitions like t
I have a Nucleo-F446RE, and I'm trying to get the I2C working with an IMU I have (LSM6DS33). I am using STM32CubeMX and checked out all the example code for my
I'm trying to interface a pressure sensor (MS5803-14BA) with my board (NUCLEO-STM32L073RZ). According to the datasheet (page 3), the pressure sensor requires s
I'm using STM32F030RCT6 with CubeMX. Device is a datalogger and RTC is the main thing that cannot fail. On Errata Sheet there is something about RTC Shadow Regi
I am working on an STM32F407 Discovery Board. But I didn't solve my clock configuration problem. I want to 168 MHz working frequency and I get help from CubeMX