'In Jmeter how to run n number of users/threads for particular duration ( eg. run100 users/threads for duration of 300 seconds )
Can anyone please help on my below doubt:
- My requirement is to run n number of users for particular duration. Eg. Run 100 users/threads for duration of 300 seconds with rampup time of 120sec.
Basically what is happening is when I run a thread group ( with 100 threads & 120 sec rampup time ) it goes fine with 1% or 2% of error. However when I run same using "jp@gc - Ultimate Thread Group" plugin with hold load for 300 seconds it shows more than 80% of error with hug number of samples executed. Here my question is, when "Thread Group" is used it shows only 1% to 2% of error however when "Ultimate Thread Group" is used it shows more than 80% of error, why ?.
Please help
Sources
This article follows the attribution requirements of Stack Overflow and is licensed under CC BY-SA 3.0.
Source: Stack Overflow
| Solution | Source |
|---|