'How can one mute an application using pipewire from CLI

I would like to automute certain audio clients when I want, without human intervention (e.g. pulling up pavucontrol) when using Fedora/pulsewire. This worked before using pacmd, but that doesn't work under pipewire; and the replacement command, pw-cli, doesn't support set-sink-input-mute or set-source-output-mute.

pw-cli doesn't seem to support muting that I could see. pw-mon shows a relevant change when using pavucontrol (or easyeffects) to mute a stream, but that didn't help me figure out how to do it myself.

linuxaudiopipewire


Solution 1:[1]

This is a bit late but i recently needed it too. Instead of pacmd you can use pactl set-sink-input-volume <sink-id> <volume>

Sources

This article follows the attribution requirements of Stack Overflow and is licensed under CC BY-SA 3.0.

Source: Stack Overflow

Solution Source
Solution 1 Yunus Emre ÖRCÜN

Related Questions