'Coral Dev Board - Startup Blocked if Display Activated
I have a Coral Dev board acquired 4/19 and activated 4/22. I purchased a ViewSonic VA1655 15.6 Inch 1080p Portable IPS Monitor with Mobile Ergonomics, USB-C and Mini HDMI for Home and Office which I power from the USB port on my 120v household power strip. (I also pimped out my Coral board with a Samsung Electronics (MZ-V8V500B/AM) 980 SSD 500GB - M.2 NVMe Interface Internal Solid State Drive with V-NAND Technology inside a SABRENT USB 3.2 Type-C Tool-Free Enclosure for M.2 PCIe NVMe and SATA SSDs (EC-SNVE) for some Gentoo chroot experiments ).
The problem I face is that if I have a crash or power down, when I try to restart by unplugging and plugging back in Coral's transformer, boot-up will not start unless I also power down the ViewSonic monitor. I believe the monitor's being "on" probably sets a voltage on the Coral board which interferes with the logic of detecting power off/power on for the reboot. Maybe I'm wrong in theory, but I would like to be able to reboot/start up Coral by plugging/unplugging the Coral's transformer and not to also have to power off the ViewSonic and then power the ViewSonic after Coral has started. Is there a configuration setting that can accomplish this?
Sources
This article follows the attribution requirements of Stack Overflow and is licensed under CC BY-SA 3.0.
Source: Stack Overflow
| Solution | Source |
|---|