'How can I make LIN master off by using CAPL?
I'm a newbie of canoe and capl. I'm trying to make a lin slave tester by using canoe, capl, panel. LIN netwotk has 2 channel.
ch1 - a bldc motor
ch2 - an actuator
And i made some functions such as voltage, current monitoring and check pass or fail. i also need to make error condition like LIN off status for a while. there were many capl functions similar what i wanna make.
- linstopscheduler
- linactivateglobalnetworkmanagement
- lindeactiveslot
- lingotosleep
- linchangeschedtable
but none of them stop sending master frame.
it shows a message
"Node 'tesr' (CAPL) LIN channel 2: LIN API call LINStopScheduler() ignored! due to LIN Interactive Master settings!"
So i turned of master simulation but schedule table also disabled forever.
how can i make it?
Sources
This article follows the attribution requirements of Stack Overflow and is licensed under CC BY-SA 3.0.
Source: Stack Overflow
| Solution | Source |
|---|